INSTALLATION GUIDE
WOODLOOK VENETIAN BLINDS:
Please Note: These instructions should be read thoroughly before installing.
This is a guide to assist in the installation and care of your blinds. Betta Blinds & Awnings does not guarantee the accuracy of the
information contained in this guide. We recommend an experienced expert installer to rely upon their own skills. This is based on
general knowledge concerning the assembly, materials and working process of the blinds, which is known to us at the time of
printing this guide, consequently, is subject to change and Betta Blinds & Awnings specifically reserves the right to change this
guide without notification.
⬧
The person installing a corded internal window covering must attach a label to the corded window covering containing the
name and contact details of the person or company responsible for the installation.
⬧
They also must ensure that any warning label or swing tag supplied with the corded window covering remains attached to the
cord.
We recommend the use of the following Tools: Steel measuring tape, Carpenter’s level, Power or battery drill & bits, Flat
blade and Phillips head screwdrivers
The following should be included for each venetian blind ordered
Mounting brackets: One left hand and One right hand
Support bracket(s) if required
Hold down brackets
– 1 pair if ordered.
We recommend clean, soft cotton gloves
(or the rubber gloves supplied)
be worn to avoid marking the fabrics when
installing and handling fabric blinds.
Since different screws are required to suit different fixing applications, we do not supply screws. Please ensure you use the correct
screws for mounting to the desired application, for example Gyprock, timber, concrete, brick, steel, or aluminium.
The most important procedure in installing these blinds is to be sure that the correct anchorage method has been used so that
the mounting area (i.e., wall or architrave) is able to support the weight of the blind and its operation
.
Note: Brick or Rendered Surfaces Warning:
Make sure drilling is no closer than 25mm from edge of surfaces as the brick
or render may chip or break out
INSTALLATION
Face & Reveal
1.
Check the marked width and drop sizes as indicated on the headbox against your original order
2.
Each blind is marked to indicate the room location, as per your order form, to assist in establishing the correct fitting
location of multiple blind orders.
3.
If all is correct layout the blinds at their location and remove protective packaging.
4.
Remove the supplied installation brackets and cords from their shipping position in the headbox.
5.
Ensure that the blind has 2 brackets (LH / RH) supplied for each blind. Note: if the width of the blind exceeds 1550mm a
centre support bracket should also be supplied and fitted. This is to be mounted off centre towards the cord lift end.
6.
As these blind brackets are universal, they can be installed either face fit or reveal.
7.
Level mounting is critical to the correct operation of the blind. (Achieved using a spirit level)
8.
Fix the brackets either left or right as marked inside the brackets to the required location
9.
These brackets have holes positioned for easy fitting through the top, sides and back sections depending on the
application needs.
10.
Betta Blinds supplies mounting brackets only and where appropriate the child safety devices.
