July 28, 2004
The Fast and the Furious Drift • Copyright 2007 • Raw Thrills Inc • All rights reserved
.
8
Game Networking
NOTICE: To link the two games together, use the crossover cable provided in the spare parts bag. Use of
another cable other than the one shipped with the game could void warranty or cause games not to link. Use
network cables which are at least CAT5 grade.
Networking Considerations
Each FNF game comes with a network cable. Optionally, a hub can be installed and located remotely to monitor
network activity.
Take care to protect exposed game wiring from general foot traffic around the game. Use a conduit or wire way to
protect the cables as needed.
Please mark linking cables for your game if other such cables are in the vicinity to avoid confusion. Network
cables are not marked or coded.
Avoid routing the network cables near sources of heat, moisture or electrical energy such as neon lights,
compressor motors, transformers etc.
Networking Setup
1. Remove the network cable from the spare parts bag inside the cashbox.
2. Connect each end of the cable to network jack behind each PC.
3. Neatly route the cable through the notch on the back of the cabinet.
4. Use the DIP switch diagram below for enabling link feature and master/slave configuration. The DIP switch is
located on the JAMMA I/O board. The JAMMA I/O board is mounted inside the back of the cabinet.
DIP SWITCH DIAGRAM
:
DIP SW#
SW1 SW2
SW3
SW4
SW5
SW6
SW7
SW8
MASTER
OFF OFF
ON
SLAVE
ON OFF
ON
5. Reset both games simultaneously and verify that link is successful. If not, check the DIP switch settings and
make sure that the network cable is connected properly and secured. Please refer to the Game
Troubleshooting Guide on this manual for more details.
Содержание Fast and the Furious Drift
Страница 1: ......
Страница 41: ......
Страница 42: ...July 28 2004 The Fast and the Furious Drift Copyright 2007 Raw Thrills Inc All rights reserved 42 ...
Страница 43: ...CONTROL PANEL ASSEMBLY ...