14
PERFORMANCE
2. OVERFLOW DEVICE
The machine is equipped with a float, which intervenes when the recovery tank is full causing the closure of
the suction hose. In this case, it is necessary to proceed with the emptying of the recovery tank taking off
the plug of the exhaust pipe.
ATTENTION!
This operation has to be carried out using gloves to protect from
contact with dangerous solutions.
3. BRUSH PRESSURE
Use lever (1) to adjust brush pressure. There are three preset positions. The greatest pressure is when the
lever is in its highest position. Pressure should be selected depending on the type of floor and the amount
of dirt. Too much pressure causes increased brush wear and greater energy consumption.
4. MOVEMENT (machines with traction)
These machines are equipped with electronically commanded traction, with two speeds forwards and one
backwards.
To move the machine, it is necessary to act upon the key (1), wait for three seconds and then rotate forward
(forward movement) or backward (rear movement) the lever (2) on the handle bar. Pushing forward the
lever a few millimetres, the first speed is available, pushing the lever forward completely, the second speed
is obtained.
In reverse motion, the speed movement is reduced.
WARNING!
When carrying out even short backward movements, make sure
that the squeegee is lifted.
5. BRAKES (machines with traction)
The machine has two braking systems: a working electronic brake integrated in the drive system (1) and an
emergency brake which works by pushing downwards the lever (2), which works also as parking brake
when it is fixed in the proper hooking down on the right.