background image

4

Operating Instructions for Commercial Spotter

WARRANTY

To protect your investment, promptly

fill in the required information on the 

warranty card included with the unit. Then mail the

card back. 

WHEN THE MACHINE IS DELIVERED…

BEFORE USING THE MACHINE

GENERAL PRECAUTIONS

Read the manual carefully and completely

before attempting to operate the unit. This manual

has important information for the use and safe

operation of this machine. Keep this manual

handy at all times. The commercial spotter will

provide years of satisfactory service if operated

and maintained according to recommendations in

the manual.

Follow these guidelines to ensure operator

safety and to maintain equipment in running

order. 

Make sure the machine is plugged into an 

electrical outlet with the same voltage rating as

WARNING

Do not expose the machine to freezing tempera-

tures.
Do not use the machine for totally dry vacuum-

ing. This machine is not fitted with a fine dust

filter.
Do not use citrus-based cleaners in this machine.
Do not use cleaning chemicals in this machine

except those recommended for commercial

extraction equipment. The use of any chemical

with abrasive additives voids the warranty.
Do not break off or pull out the ground prong on

the plug.
Do not attempt repair on a warranted machine

unless instructions to perform it by an authorized

shop are obtained from the factory.
Do not use any replacement parts except those 

specified on the parts list. Proper performance of

the machine could be affected if substitutions are

made.
Use defoamer at all times to prevent damaging

the vacuum motor.
Do not use water in excess of 140° F (62° C). 

Failure to comply with the above warning 

instructions will void the warranty.

shown on the nameplate of the machine. 

Do not attempt to plug a 115 volt machine into 

a 230 volt outlet or a 230 volt machine into a 

115 volt outlet. 

Disconnect the power cord from the outlet before

attempting maintenance or repair work.

Do not leave machine connected to an electrical

outlet when unattended.

Never pull the machine by the cord or yank the

cord from the receptacle. Replace a damaged 

cord immediately.

If an extension cord is necessary, use a three 

conductor grounding cord – 12 gauge wire or

heavier to prevent motor burnout and 

over-heating of wires.
To avoid electric shock, do not expose to rain.

Store indoors.
To avoid fire, do not use machine in environ-

ments where combustible liquids, vapors or dust

concentrations are present.

Check the carton carefully for signs of rough han-
dling. Remove the machine from the carton. If the
machine is damaged, notify the carrier immediately
and request an inspection. Be sure to keep the car-
ton, packing inserts, packing lists and carrier
receipt until the inspector has verified your claim.
Liability ceases when the shipment is picked up by
the carrier, but our  customer service staff will be
glad to furnish any  information needed in connec-
tion with the claim and will expedite the repair of
the machine.

Содержание E85509-00 fiberpro









Отзывы: