Betatech PROGRAMMABLE CONTROL KEYBOARD, Руководство пользователя

Страница: 6 / 10

Page 6
3.2.4. Sequence Operation mode
In this mode of operation, the numeric keypad selects the active sequence. The left and right arrow buttons cover the
same functions as the “Previous” and “Next” buttons. Pressing the up arrow key will initiate the currently selected
sequence. Pressing the down arrow key will terminate the sequence.
3.2.5. Alarm Acceptance
Alarms may optionally be set up (by the main CCTV control system) in such a way that the operator will be alerted by
an alarm tone and the flashing of the “Alarm Ack” LED. To accept an alarm the operator must press the “Alarm Ack”
key.
3.2.6. User Function Keys
During “Camera”, “Monitor”, “VCR” or “Sequence” mode of operation, pressing the function keys “User 1” to “User
4” will result in sequences being started. by the main controller. Setting up which sequence is to be started is a function
of the CCTV system main controller.
4. PCK CONFIGURATION
Various Parameters of the PCK may be configured. This allows for the setting of baud rate, unit address and reversal of
the Y axis of the attached joystick.
4.1. Setting the Unit Address
The currently selected unit address is displayed when the PCK is powered up. If there is only 1 PCK in the system, the
unit address should be set to 1. Should there be more than 1 PCK, they should be set to be at unique addresses, starting
at 1.
To change the unit address switch the unit off and while holding down the “Store” button press one of the following
buttons to set the new unit address:
Key Unit Address
0 Master PTZ Controller
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
0 10
Seq 11
Menu 12
Login 13
Next 14
Prev 15
Clear 16
Note that once selected, the unit address is stored internally and will not be lost when the unit is powered down.