BETAFPV Lite brushed V2 FC, Руководство пользователя

Страница: 13 / 16

12
7.2 Armed & Disarm
If you use a radio transmitter with full 7 channels, you could use the default channel 5
to arm and disarm the drone. It is the same as Betaflight firmware.
If you use a toy radio transmitter like LiteRadio 1 below, there is no additional
channels. So you could active the toy transmitter status. No arming needed, just
throttle up and the motors spin.
Enter the OSD menu and go to the Config page. Set the TOY_TX to Y. Do not forget
to save the config.
7.3 Flight Mode
Lite Brushed FC V2 still uses the channel combination to arm and switch flight mode.

Disarm: CH5 is AUX Low

Arm: CH5 is AUX High

Turtle
：
CH6 is AUX Low, CH7 is AUX High

Acromode
：
CH6 is AUX Low, CH7 is AUX Low

Levelmode
：
CH6 is AUX High, CH7 is AUX Low
，
CH8 is AUX Low

Racemode_angle
：
CH6 is AUX High, CH7 is AUX High, CH8 is AUX LOW

Racemode_horizon: CH6 is AUX High, CH7 is AUX High, CH8 is AUX High

Horizonmode
：
CH6 is AUX Hight,CH7 is AUX Low
，
CH8 is AUX High