Beta X-Trainer 300 2T, Руководство пользователя

Страница: 29 / 82

2
OPERA
TION
29
GB
7.3 Mixer system indicator light
3
When you start the vehicle, the system performs a diagnosis check, while the indica-
tor lights for 10 seconds (check). If the indicator comes on during normal operation,
or the start check failure, they indicate a fault in the mixer system.
If the indicator comes on during normal operation, it tndicates a fault in the mixer
system. In this case stop the engine immediately, empty the fuel tank and refuel with
mixture at 1.6%. Then go to an authorized Betamotor service as soon as possible.
7.4 Mixer oil reserve indicator light
4
If the warning light comes on, refuel as soon as possible. The mixer tank reserve
is indicated on page 10. Refuel with special oil as indicated in the “Table of
Lubricants and Recommended Liquids” on page 16.
CHECKS BEFORE AND AFTER USE
For safe driving and long vehicle life you should:
1 Check the integrity of the oil pipe connecting the intake manifold to the electronic dosing.
2 Check all fluid levels.
3 Check the correct operation of the brakes and brake pad wear (page 54).
4 Check pressure, general condition and thickness of tread (page 63).
5 Check that the spokes are properly tightened.
6 Check the tensioning of the chain (page 63).
7 Check the adjustment and the operation of all the cable controls.
8 Inspect all the nuts and bolts.
9 With the engine running, check the operation of the headlight, the rear and brake
lights, the indicators, the warning lights and the horn.
10 Wash the motorcycle thoroughly after off-road use (page 69).
RUNNING IN
The running-in period lasts approximately 15 hours, during which it is advisable to:
1 Make the first refuelling with a mixture of 1%.
2 Use the oil indicated on page 16 in the “Recommended lubricants and liquids” table.
3 During the first 3 hours of operation the engine should only be used to approximately
70 percent of its power. In addition, the engine speed should not exceed 7,000 rpm.
4 For the next 2 hours of operation the engine should only be used to about 90
percent of its power.
5 Use the vehicle after properly warming up the engine.
6 Avoid travelling at constant speed (changing the speed causes the different com-
ponents to bed in evenly and more quickly).
This procedure should be followed each time piston, piston rings, cylinder, crankshaft
or crankshaft bearings are replaced.
WARNING
Replace the transmission oil after the first 3 hours or after 15 l. of mixture.