7. POWER SUPPLY
a. Make sure the local voltage complies with the voltage requirement indicated on the back label of the
amplifier before connecting the amplifier to the power socket.
b. Make sure the power cord and the power socket are both undamaged, and whether they are compatible,
before connecting the amplifier to the power socket.
c. Make sure the metal parts of the chassis have a reliable grounding (earthing) after connecting the
amplifier to the power socket.
d. Unplug the power cord when the amplifier is turned off to ensure safety.
e. Please refer to the power supply requirements on the parameter sheet for the power capacity of the
amplifier. It is recommended to reserve 1.5 times the power margin during actual use.
7
XLR unbalanced
·
XLR asymetrique
·
unsymetri is che XLR
·
XLR no balanceado
1
2
3
TRS unbalanced
·
TRS asymetrique
·
TRS no balanceado
·
Unsymetriscbe jStereoklinke
·
·
Asymetrique
·
Unsymmetrisch
·
No balanceado
Unbalanced
non-inverting input +
Ground
1
2
3
·
Balanced
·
Symetrique
·
Symmetrisch
·
Balanceado
Ground
inverting input -
non-inverting input +
Note: Before use, please ensure the grounding of the power socket is reliable, and the
grounding between the metal chassis of this product and the power socket is well-grounded
as well. Otherwise, it may cause an electric shock.
8. INPUT/OUTPUT CONNECTORS
INPUT CONNECTORS
The product is designed with balance input circuit to lower noise,please use balance connection
for the device.
Note: Even if your signal output device is designed with an unbalanced line, please avoid using
a single core shielded cable to prevent additional noise. Please connect the negative pole of the
dual-core shielded cable to the ground at the signal source, and connect it in a balanced method
at the input end of the amplifier. This will achieve the same noise suppression effects as a
balanced transmission.
Each channel has an XLR input socket. In the link mode, the input sockets between the link
channels are in parallel connection directly, and you can input signals into the sockets of any
one of these channels.
Depending on the product model, the link output sockets have different XLR and TRS
configurations, which are in parallel connection directly with the input sockets of the
corresponding channels. Output signals are transmitted from these ports to connect to another
amplifier, and they can be grouped and linked as needed. This link method is extremely
convenient, but please do not link too much to reduce interference and loss of signal,
which may also cause damages resulting from oscillation.
Note: Please do not input signals into both of the channel input sockets simultaneously when
it is in the LINK mode, to prevent malfunctioning of the amplifier.
Mode option and signal cable connection
as right drawing
Diagram of the pin position of the cable plug