Windjammer™ – Installation Instructions
to Install Behind
Front
Seat, continued
Rev. E 0416
80039 pg.
5
Pull the flap on the rear of the Windjammer™ out over the top of the
front edge of the Duster™
Extension
.
Rub chalk on the snaps on the Windjammer™ flap. Pull up on the
front reinforced edge of the Duster™
Extension
and press the snaps
against the Duster™
Extension
to mark the locations.
At the marked locations, push the sharp end of a Snap Head Screw
through the Duster™
Extension
from the backing side and through
both layers of fabric, to make a hole. Once the hole is formed, pull the
screw back out of the hole. Then push the screw through the hole
from the vinyl side so that the snap is on top of the vinyl. Install an
Acorn Locknut over the pointed end of the Snap Head Screw.
Install Snaps to Secure Duster™
Extension
to Windjammer™ – Optional
Fabric –
Backing Up
Fabric –
Vinyl Up
Push Snap Head
Screw through to
form a hole
Acorn Locknut –
Under Fabric
Snap Head
Screw
Secure Outside Straps
Wrap the outside straps around the sport bar to the
outside and thread the ends through the buckles.
Tighten all the straps.
To secure the loose end of the straps, roll the ends,
if necessary, and fasten the hook and loop.
Outside of Vehicle
Sport Bar
Wrap Straps
around Sport Bar
