Trektop™ – Installation Instructions
Rev. C 0209
56801 / 56802 pg. 2
Parts List and Hardware Identifi cation
Top Fabric
Qty - 1
Rear Window
Qty - 1
Self-Adhesive Hook Strip, 55"
Qty - 1
Header, Part Number
378.36, Qty - 1
Install Header
5/16" Flat Washer,
Qty - 8, Part
Number 233.04
End Cap, Part
Number 401.56,
Qty - 2
Tension Strap, Part
Number 453.82, Qty - 2
J-Hook Brackets, Qty - 2,
Part Number 378.61
5/16 x 1-1/4" Bolt,
Qty - 2, Part
Number 378.59
Door Surround -
Left, Part Number
454.77, Qty - 1
Door Surround -
Right, Part Number
454.76, Qty - 1
#10 Phillips Head Self Tapping Screw,
Qty - 8, Part Number 319.99
Front Door Surround
Brackets, Qty - 4, Part
Number 454.66
5/16-18 x 1" Phillips Head Bolt,
Qty - 2, Part Number 236.20
1/4-20 x 2-1/4" Screw, Qty - 4
5/16-18 Tapping Plate, Qty - 2,
Part Number 200.50
Place the Header assembly on top of the bulb seal along the
top of the Windshield.
Locate the two J-Hook Brackets in the parts kit. Orient a bracket
with the hook toward the front and the threaded insert toward
the top. Slide the bracket into one of the J-Hook Bracket Bases
mounted to the Windshield Retainer and catch the hook in the
slot in the windshield. Insert a 5/16 x 1-1/4" Bolt and a 5/16"
Washer from the top of the base into the J-Hook Bracket to
secure the bracket to the base. Repeat this on the other side
of the vehicle.
While installing the Header/J-Hook Bracket As-
sembly, apply fi rm pressure toward the front of the
vehicle to make sure that the assembly is installed correctly
over the bulb seal.
5/16" Washer
J-Hook Bracket
- Hook into slot
in windshield
5/16 x 1-1/4" Bolt
J-Hook
Bracket Base
Header
Windshield
Frame
Windshield
Retainer
Cross Section
Header
Bulb
Seal
Push Down
Here
J-Hook Bracket -
Hook into slot in
windshield
5/16"
Washer
5/16 x 1-1/4"
Bolt
46" Bow, Part Number
454.75, Qty - 1
1/4-20 Lock Nut,
Qty - 4, Part
Number 436.17
