PowerBoard – Installation Instructions
Rev. K 1011
75134 pg. 4
Open the passenger door and remove the sill plate
and kick panel.
Remove Kick Panel
Connect the Controller to the vehicle wire loom.
Connect both connectors on the Wire Harness in the
parts kit to the connectors on the Controller. Secure
the locking tabs on the connectors.
Connect Controller to Wire
Loom and Wire Harness
Run the legs of the Wire Harness
down and along under the vehicle.
Use Cable Ties to secure it.
Run the trugger wires on the
passenger side through the
grommet as shown.
Controller
Connect the Controller power and ground
to battery, red lead to positive and black
lead to negative.
Route the Wire Harness legs down to the
wheels wells and to the Motor Linkages.
The long leg goes across the front to the
driver’s side.
Use Cable Ties to secure all loose
sections of the harness.
Secure Controller and
Wire Harness
Cable
Ties
Route Wire Harness
Driver’s Side
Wire
Harness
Cable
Ties
Passenger Side
Trigger Wires
Cable
Tie
Wire
Harness
