Section 3
Install Seat Bottom Covers
P8 - 29283 - Rev. D 1115
© 2015 Bestop, Inc.
Page 8
Step 1
Step 2
Installation Instructions - Seat Covers, Front Kit
Step 1
Attach the two ends of the elastic cords
to the closed end of the the s-hook. Attach the
s-hook to a cross-member or wire underneath the
seat, making sure to keep the cords away from
the seat adjustment tracks.
Attach the 4 nylon straps at the front of the
underside of the seat to the buckles.
Give the straps a gentle tug to snug the covers.
Verify the straps do not interfere with or unplug
any of the wiring found under the seat.
Make sure that the seat will tilt forward and back,
and slide from front to back without the seat rail
snagging the straps.
Step 2
Slip the seat bottom cover over the seat, working
the fabric toward the rear of the seat. Carefully fit
the hole in the fabric over and around the seat
height adjustment lever.
Tuck the nylon straps between the seatback and
the seat bottom, and bring them to the front of the
underside of the seat.
Tuck the flap between the seatback and seat
bottom, and attach the hook-&-loop fabric tab on
the inside of the seat cover flap to the carpeted
area underneath the rear of the seat bottom.
Note: Tilting the
seatback forward slightly
will allow easier access
to tuck the straps and
the flap between the
seatback and seat bottom.
2
1
Hole in fabric
fits over seat-height
adjustment lever
Hook-&-Loop
Fabric Tab
