BESTEK NSP-20H1, Руководство пользователя

Страница: 47 / 47

47
Q: System does not boot from USB Pen Drive
A: Please check the following before you call out for help:
(1) USB Pen Drive is not well plugged on USB port.
(2) Check in the BIOS that USB Pen Drive has not been detected.
(3) Check in the BIOS that USB Pen Drive has not been selected as the first boot device.
(4) Make sure your USB Pen Drive comes with a firmware designed for booting.
Q: I cannot connect my network with internet
A: Please consult your system administrator to confirm if a static network environment with security port
designation has been deployed. Otherwise, mostly, reassuring to have Windows acquiring IP address automatically
would be suggested and should resolve the situation. Please be referred to your system administrator for any
further network configuration setting. Please also manage to confirm that Bypass function of the port in question
is not enabled as this will interrupt the connector between RJ45 port and network chip.
Q: Can I enable Bypass function at Power Off mode?
A: Yes, you certainly can. NSP-20H1 comes with dual-latch relay that will work at both power on and power off
mode.
Q: Can I use Console Port at BIOS mode?
A: Yes, you certainly can. NSP-20H1 comes with one console port as RJ45 at front side. Please manage to find the
console cable in the accessory bag, add the RJ45 end to console port, and the other end to the DB9 RS-232 port of
a Windows PC (for example, Windows-XP) that comes with terminal software (for example, Hyper Terminal). To
start console function, please make sure console function is enabled, and a proper baud rate is selected. Also of
great importance on the terminal software at Windows-PC, a correct serial port has been selected, and a baud rate
at which NSP-20H1 has been configured is selected. Upon power on and bringing up BIOS menu, similar message
will be popping on terminal pane.
Please be noted that no console message will be available on terminal pane out of BIOS (i.e., at run-time), unless
user has managed to send console message over the console port by programming.