27
When the system is powered on, the BIOS will initiate the Power-On-Self-Test (POST) routines. These routines
perform various diagnostic checks. If an error is encountered, the error will be reported in one of two different ways:
If the error occurs before the display device is initialized, a series of beeps will be transmitted.
If the error occurs after the display device is initialized, the screen will display the error message.
Powering on the computer and immediately pressing <
Del
> allows you to enter Setup. Another way to enter Setup is
to power on the computer and wait for the following message during the POST:
TO ENTER SETUP BEFORE BOOT
PRESS <CTRL-ALT-ESC> OR <DEL> KEY
Press the <
Del
> key or press the <
Ctrl
>, <
Alt
>, and <
Esc
> keys to enter Setup.
The online description of the highlighted setup item is displayed at the right pane of the menu at all time.
Press F1 to pop up a small help window that lists all the function keys and its use.
To exit the Help Window, press
<F1>
or
<Esc>
.
The table below lists all the function keys for the navigation in the BIOS setup menu.
Function Key
Description
Up/Down Arrow Key
Move Up/Down
Left/Right Arrow Key
Move Left/Right
Enter Key
Select
+/- Key
Change value
ESC
Exit
Tab
Select a Field
F1
General Help
F2
Previous Values
F3
Optimized Values
F4
Save & Exit
To exit the Help Window, press
<F1>
or
<Esc>
.
4.1 Entering Setup
4.2 Getting Help
4.3 Control Keys
Содержание BNX-E38
