Best BestReach BRR23030, Инструкция по эксплуатации, техническому обслуживанию и запасным частям, Страница: 9 / 76

9
Unloading Units
1) Upon arrival all conveyors will be secured with wood blocks mounted to the trailer floor.
All wood blocks must be removed prior to moving the conveyors.
2) Warning: Conveyors must not be picked up utilizing forks on the rear of the unit. Failure
to adhere to this warning may cause damage to the main electrical panel on the back of
the unit, or the electrical connections coming into this panel. This damage will not be
covered under warranty.
3) To unload, the unit may be either manually pushed from the front of the conveyor, or by
utilizing a lifting strap placed around the rear frame of the conveyor and attached to a
forklift. If using the strap method, make sure that the strap does not come in contact
with any electrical wiring under the conveyor.
4) The steering actuator on the front axle of the conveyor has been disconnected for ease
of movement. When using either unloading method, someone must manually steer the
front of the unit to prevent damage to the front control panel.
Installation
Installation should only be performed by Best Conveyor Installers or qualified personnel, and
must be completed in accordance with all applicable codes and regulations.
1) Locate and mark the center of the spur. Chalk a line from the dock leveler back
approximately 50 feet. Measure 2 inches off each side of the centerline, this will give
you the inside dimension on track placement location, 5 inches off the center will give
you the outside line placement. NOTE: It might be helpful to cut 2, 4-inch blocks.
Center these blocks on your chalk line at the front and back of each piece of track, so
that you have 2 inches on either side of the line. Proceed to assemble the track as
instructed below.
2) Mark location for the front of floor track as shown on supplied application specific
drawing (if you do not have this drawing, please contact the factory.)
3) Locate and position the individual pieces of floor track as shown on drawing A.
4) Assemble the rear sections of floor track as shown in drawing B.
5) Position and anchor floor track starting with the front and aligning the inside edge with
the 2-inch or 5 inch measure out, or utilize your cut blocks for this placement.
6) Pull 2 lengths of SO cable (50’ 18/10 and 60’ 14/4) through flexible wire carrier.
7) Attach the included connection brackets to each end of the flexible wire carrier. These
parts and hardware are shown in Drawing C on page 14.
8) Feed both lengths of SO cable under rear wire cover (C channel illustrated in Drawing B
on page 13 Item # 7) exposing approximately 10” at the rear of the floor track. Attach
the flexible carrier to the wire cover (C channel).
9) Install 2 cord grips (not included) in 7/8 holes of 8x6x5 junction box that is provided.
Installation
(continued)