2.
Repeat Steps 10 thru 12 to install
the gable on the front wall.
2.
Install a 48" long 2x4 next.
3.
Remove 2x4 bracing door opening.
Cut to fit and install to finish .
4.
Repeat to install 2x4s on the opposite
side wall.
Step 12
Install Rear Gable Siding
1.
Install gable siding on the back gable using 6d
galv. nails. The gable siding should extend no
more than 1/2" above the 2x4 frame and 1-1/2"
past gable ends.
Step 11
Install 'Z' Flashing
Step 13
Install 2x4 Truss Headers
1.
Place a 72" long 2x4 on top of the siding on the side wall. It will butt against the siding on the
rear gable. Nail this 2x4 to the 2x4 tie plate with 10d sinkers.
2x4-72" Board
Side Wall Siding
60" Long 'Z' Flashing
Roof Gable
Back Wall Siding
Install (2) two 60” pieces of 'Z' flashing
across the top of the siding on the end
wall siding. Secure in place using 6d galv.
nails spaced 12” apart. The ends will be
covered by corner trim.
1-1/2" Past End
of Gable
