X
X
X
X
X
X
A
A
B
B
X
X
X
X
Step 1
Assemble Back Wall
1.
Position (4) four 60" boards together and indicate with 'X' marks, where the wall studs
will be located. Mark the ends that will butt together with the letters 'A' and 'B'.
2.
Install 72" wall studs between the top and bottom plates. Assemble wall frames with
10d sinkers. Use (2) two nails at end of each wall stud.
24"
23-1/4"
60" Wall Plate
X
X
60" Wall Plate
24"
11-1/4"
X
X
X
X
Siding Extends 3/4" Below Plate
LAP Edge
60" Wall Plate
Tongue Edge
Cut Edge
A
B
3.
Nail both wall frames together
using 10d sinkers.
4.
Square wall frame, measure diagonally (corner to corner). The measurement should
be 141-1/2".
5.
Repeat steps 1-4 to assemble next end wall frame.
6.
Select a 36-3/4" wide siding panel with a 'tongue' edge. Install this panel with the 'Cut'
edge flush with the end of the wall frame. Install siding flush with the 2x4 top plate.
Use 6d galv. nails spaced 12" on center.
7.
Install a full width x 75-3/4" long siding panel next.
8.
Install a 36" x 75-3/4" siding panel last. If
necessary trim panel flush with 2x4.
