
8
mode, the meter displays values from 0.30 up to 1.00. The factory
default setting is 0.50.
How to Program the Species Setting:
1. Use the species settings table on pages 13-23 to find the specific
gravity setting that corresponds to the type/species of wood that
you wish to measure.
2. When the meter is turned on, press and release the Species but-
ton. The display will show the current SG setting (e.g., 0.60). If
the meter is being programmed for the first time, the default
setting of 0.50 will be displayed.
3. Pressing and releasing either the Up or Down buttons will increase
or decrease the SG setting of the meter by .01 each time. If you
press and hold either the Up or Down button, this will allow the SG
setting to increase or decrease by multiples of .10, and until you
release the Up or Down button, the display will continue to adjust
by multiples of 0.10, allowing you to quickly get to the SG setting
you need.
4. Once the SG setting you need is displayed, press either the
Species button or the On/Hold button to return to Standard
Measurement mode and begin taking measurements.
5. The programmed SG setting will be stored in the meter’s
memory even if the meter is turned off or the battery has been
changed. You can verify this each time you use your meter
simply by pressing the Species button when the meter is turned
on. The last programmed setting will be displayed.
Содержание D300
Страница 1: ...MANUAL ...
Страница 25: ...23 Plywood OSB and MDF Setting Plywood 0 57 OSB 0 62 Permacore MDF 0 70 HDF core 0 85 Advantech 0 70 ...
Страница 26: ...24 NOTES ...
Страница 27: ...25 NOTES ...