BESAFE iZi Plus, Руководство пользователя

Страница: 6 / 8

16 17
• It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
• Install only with 3-point car belts, approved to UN/
ECE Regulation No. 16 or other equivalent standards. (41)
• DO NOT use the seat without floor support in the most
downward position, supported by the floor in front of the
vehicle seat.
• DO NOT use the seat without tightening the front brace when
mounted rearward-facing.
• DO NOT use the seat without tightening the anchor belts when
mounted rearward-facing.
! Warning: potential misuse
! Important advice
• DO NOT attempt to dismantle, modify or add any part to the
seat. Warranty will expire if non-original parts or accessories
are used.
• DO NOT use anything, such as a cushion, to raise the child
seat off the passenger seat of the vehicle. In an accident the
seat will not be able to protect your child in the right way.
• Never leave your child unattended in the seat.
• Make sure all passengers are informed about how to release
your child in case of emergency.
• An unoccupied child seat should always be fastened in
the vehicle.
• Make sure luggage or other objects are properly secured.
Unsecured luggage may cause severe injuries to children and
adults in case of accidents.
• Never use the seat without the cover. The cover is a safety
feature and may only be replaced by an original BeSafe cover.
• Under the cover we use EPS foam. Do not push or pull too
hard against the foam, since you might damage the foam.
• Pay attention when you remove the cover, as fitting the cover
is done in the opposite way.
• Start to take off the lower seat part. (40)
• The cover of the head rest can be taken off separately by
disconnecting the hooks at the backside and pulling off the
fabric to the front.
• Pull the head rest in the highest position. Mount the head rest
cover and connect the hooks at the back side. Pull the harness
straps through the holes. Connect the loose bottom part of the
head rest fabric with the plastic part under the head rest.
• Pull the harness straps through the opening of the seat cover
and lock the harness buckle. Pull the crotch strap through the
opening of the seat part.
• Mount the top part and then the shoulder parts. Mount the
seat part and bring the seat cover under the rear parts of the
sidewalls.
Removing and refitting the cover
Removing the cover
Refit the cover
Cleaning instructions
• The fabric covers shall be washed according to the
instructions on the inside of the covers.
• Clean harness by hand with water and mild soap.
• DO NOT use any aggressive cleaning products; these may
harm the construction material of the seat.