Furniture Wall Safety Strap
Hardware List
SAFETY WALL STRAP 1 PC
TOOLS NECESSARY: RUBBER MALLET AND PHILLIPS SCREW DRIVER ARE NOT INCLUDED.
NOTE: 5/16" DRILL BIT AND ELECTRIC DRILL ARE NOT PROVIDED.
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE
USING THIS PRODUCT AND KEEP THESE INSTRUCTIONS FOR
FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS, PLEASE
CALL OUR CUSTOMER SERVICE NUMBER: (800) 295-1980.
TO MOVE THE FURNITURE AFTER THE SAFETY WALL STRAP HAS BEEN INSTALLED, SIMPLY
REMOVE THE SCREW (PART A) FROM THE WALL TO LOOSEN THE SAFETY WALL STRAP.
STEP 2:
USING A RUBBER MALLET, HAMMER THE WALL
ANCHOR (PART D) INTO THE DRILLED HOLE UNTIL THE
OPENING OF THE WALL ANCHOR (PART D) IS EVEN WITH THE
WALL.
STEP 3:
MAKE A MARK ON THE BACK FRAME OF THE
FURNITURE (AT THE MIDDLE POSITION OF THE TOP PANEL
BACKSIDE, WHERE YOU WOULD LIKE TO INSTALL THE
SAFETY WALL STRAP). INSERT THE SHORT SCREW (PART C)
AND THE SAFETY WALL STRAP (E) INTO THE METAL
BRACKET (PART B), THEN INSTALL IT INTO WHERE THE
MARK WAS MADE WITH A PHILLIPS SCREW-DRIVER,AS
SHOWN IN RIGHT SIDE.
STEP 4:
TO INSTALL THE SAFETY WALL STRAP (E) TO THE
WALL, INSERT THE LONG SCREW (PART A) AND THE SAFETY
WALL STRAP (PART E) THROUGH THE METAL BRACKET
(PART B) AND SECURE THE SCREW (PART A) INTO THE WALL
ANCHOR (PART D) USING THE PHILLIPS SCREW DRIVER. AND
THEN PUT THE TAIL OF SAFETY WALL STRAP (E) TO THE
HOLE OF SAFETY WALL STRAP (E) HEAD, PULL IT FOR
TIGHTEN THE STRAP.
LONG SCREW 1 PC
METAL BRACKET 2 PCS
SHORT SCREW 1 PC
WARNING: WHEN UPRIGHT, IT IS POSSIBLE THAT THE
FURNITURE MAY TIP OVER. PLEASE INSTALL THE SAFETY WALL
STRAP BEHIND THE FURNITURE TO ENSURE SAFETY.
STEP 1:
LOCATE AND MARK A SPOT ON THE WALL BEHIND
THE FURNITURE (ABOUT 2" to 3" BELOW THE TOP OF THE
FURNITURE), AND SLIDE THE FURNITURE AWAY FROM THE
WALL, ALLOWING YOURSELF ENOUGH ROOM TO WORK.
USING A 5/16" DRILL BIT, DRILL A HOLE, (ABOUT 1-1/4" DEEP)
AT WHERE THE MARK IS LOCATED.
C B D
E
A
B B
A
B
C
HOLE
D
A
C
B
B
D
