Bertazzoni W906MFE Series, Инструкция по установке, обслуживанию и эксплуатации

Страница: 6 / 20

6
Electric Multifunction Oven
TYPES OF POWER CORDS
The appliance is equipped with a terminal for the electric connection placed behind, which is accessible removing the
posterior casing (Fig.16A)
The cable of alimentation can be :
Operation at 220-240V
~
: use a H05BB-F three-wire cable (cable 3x6 mm²)
Operation at 380-415V2N ~ : use a H05RR-F o H07RN-F four-wire cable (cable 4x6 mm²)
Operation at 380-415V3N ~ : use a H05RR-F o H07RN-F five-wire cable (cable 5x4 mm²)
Fig.16B
The power supply cable is suitable for appliance operating on 220-240 V~
BEFORE LEAVING
When the installation is complete, always check for gas leaks using a soapy solution. Never use a flame to make this
check.
Ignite all burners on high flame to ensure correct operation of gas valves, burners and ignition. Turn gas taps to low
flame position and observe each burner to ensure they ignite completely at all ports and that the flame is stable. Conduct
these checks for each burner individually and concurrently.
When satisfied with the appliance, please instruct the user on the correct method of operation. In case the appliance fails
to operate correctly after all checks have been carried out, please call the Bertazzoni Service Centre.
APPLIANCE MAINTENANCE
ATTENTION: IMPORTANT WARNINGS
For cookers resting on a base
ATTENTION: If the cooker rests on a base, take the measures necessary to prevent the cooker from sliding along the
support base.
For cookers with glass covers
ATTENTION: Before opening the appliance’s glass cover, carefully remove all liquid residues from the top of it.
ATTENTION: Before closing the appliance’s glass cover, make sure that the work surface has cooled.
For cookers with electric ovens
During use, the appliance becomes hot. Care should be taken to avoid touching heating elements inside the oven.
For cookers with electric ovens
WARNING: Accessible parts may become hot during use. To avoid burns, young children should be kept away.
For the food warmer compartment (or drop leaf in our case)
ATTENTION: The internal parts of the food warmer can become hot during use.
For glass doors
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the
surface, which may result in shattering of the glass.
Do not use steam cleaners to clean the appliance.
REPLACING PARTS
Before performing any maintenance operation, disconnect the appliance from the gas supply and electricity
network.
To replace parts such as knobs and burners, just remove them from the seats without disassembling any part of the
cooker.
To replace parts such as nozzle supports, valves and electric components follow the procedure described in the burner
adjustment paragraph. To replace the valve or the gas thermostat, it is also necessary to disassemble the two rear gas
train brackets, loosening the 4 screws (2 per bracket) that attach it to the rest of the cooker and, unscrew the nuts that
attach the front burner valves to the control support, after removing all the knobs. To replace the gas or electric
thermostat, also disassemble the rear cooker guard, loosening the relative screws, to be able to pull out and reposition
the thermostat bulb.
To replace the oven bulb, just unscrew the protection cap that projects out inside the oven. (Fig.17)
WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric
shock.
WARNING
: The power cord supplied with the appliance is connected to that appliance with a Y type connection (in
compliance with standards EN 60335-1, EN 60335-2-6 and subsequent amendments) for which it must be replaced by
the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
If the power cord becomes worn or damaged, replace it based on the information reported in table 3 .
WARNING: If the power cord is replaced, the installer shall ensure that the ground cable is longer than the
phase cables and also shall comply with the warnings regarding the electric connection.