Bertazzoni p304ime, Инструкция по использованию и уходу, Страница: 12 / 36

12
A beep confirms that the new value was accepted
correctly.
To cancel the timer, hold [T-] key until the value
decrease to “00” or touch both [T-] and [T+]
simultaneously in order to reset the value to “00”
rapidly.
In some models the timer can be set in relation
with a cooking zone:
• Select the cooking zone you want to time.
• Touch [T-] or [T+], the timer led related to the
zone starts flashing.
• Set the timer value.
• The timer led gets steady, the value is accepted
and the countdown begins.
If more than one timer is set, the display shows
the lowest value, the one that will expire first. The
timer led (ref.4) related to the zone which the
displayed value is referring to, is flashing. If the
displayed value refers to the independent timer,
the timer led (ref.2) flashes.
Figure 10.
To check the remaining time for any one of the
timed zone, touch the [ON] key related to the
zone: the corresponding timer led will begin to
flash and the value on the timer display will switch
for some seconds to the new value. After a time-
out, it will switch back to the shortest one.
To check the independent timer value when it’s
not displayed with the highest priority, touch [T-]
or [T+] when no zones are selected. The timer led
(ref.4) flashes and the displayed value switches to
the independent timer.
When the timer value elapses:
• An end of activity beep sequence sounds: three
short beeps followed by a long interval are
repeated for 1 minute.
• The led indicator related to the elapsed timer
flashes.
• The timer value “00” flashes too and will
continue to flash waiting for a user confirmation.
• Touch [T-] or [T+] to cancel the expired timer,
the display switches to the next shortest timer or
gets blank if there aren’t any other timer set.
WARNING: the timer is only intended as a n
acoustic advisor that recalls the attention of
the user.
Timers have no effect on the heating elements.
The cooking zone must al ways be stop ped
manually by touching the related [OFF] key.
Rest Heat
The HOT SURFACE indicators remain on even
after the end of the cooking activity, just the
necessary time to let the surface cool down below
a safety value.
Figure 11.
The residual heat time depends on the power
level that was set on the cooking zone and the
time the heating element has been working for.
For example, a cooking zone that has been
working for more than 5 minutes at full power will
take half an hour to cool down before the Residual
Heat indication fades away. At level 1 it will take
about 10 minutes.
Features
The control is checking its own ambient
temperature and stops any activity in case of
overheating of inner parts. Let the appliance cool
down.