Bertazzoni DW18PR, Руководство по установке

Страница: 20 / 25

INSTALLING THE DISHWASHER
Case 2. With disposal
Check the size of the sink's drain hose connector(21mm- as shown in Figure 11 below). If the end
of the drain hose does not fit onto the drain hose connector of the sink, use an adaptor
purchasable at a plumbing/hardware supply store.
Slide a hose clamp over the end of the drain hose. Attach the drain hose to the sink connector,
slide the hose clamp to the end of the hose, and then tighten the hose clamp.
Note : You must use a hose clamp. Failure to do so may cause water leakage.
If there is no air gap, make sure to hang. the middle of the drain hose well above the sink cabinet
base to prevent backflow (see Figure 13 on the next page).
When drilling a hole for the drain hose on the cabinet wall, take caution not to damage the drain
hose by sharp edges of the hole. On wooden walls, use sand paper to soften the edges.On metal
walls, use insulation tape or duct tape to cover the sharp edges around the hole.
Take caution not the damage the drain hose when installing the dishwasher on the floor, wall,or
cabinet. 3.
4.
5.
6.
7.
To prevent leaks or drainage problems, make sure the drain hose is not damaged, kinked,
or twisted.
8. Do not cut the wrinkled area of the drain hose to fit the size. When arranging the drain hose, take
caution not to contact on sharp edges of the cabinet or under-sink.
Be careful when cutting off the end of the drain hose as there is a risk of injury. Clean around
the sink's drain connection so that it does not damage the hose. Check for any foreign items in
the drain hose and remove them.
When arranging the drain hose, make sure the drain hose is not cut, torn, or broken by any
sharp edges of the floor, the product itself, or the cabinet. A damaged drain hose causes a leak.
20
Drain hose2
With disposal Disposal with an air gap