M
ASTERING
Y
OUR
BERNINA
®
9/1/02
S
ECTION
A
artista 200 Embroidery
/7
BERNINA
®
artista 200 Embroidery
M
ASTERING
Y
OUR
BERNINA
®
- Template surface marked in 1cm squares
- Each template has cut-outs to facilitate transfer of markings to fabric
- There are finger holes for easy removal purposes in the small and medium hoop templates
- With the large oval and Mega hoop templates, there are special attachment clips that allow for easy
removal
• Secure fabric/stabilizer in the hoop
- Lay the outer hoop on a HARD, FLAT surface
- Secure stabilizer to the back of the fabric by lightly coating stabilizer with 505 temporary spray adhesive
- Place fabric and stabilizer on a firm surface
- Position template inside the inner hoop
- Position inner hoop on the fabric, aligning any markings on the fabric
- Grasping both inner hoop and fabric/stabilizer, insert into the outer hoop, making sure to align the arrows
at the edges of both the inner and outer hoops
- DO NOT DISTORT the fabric when tightening the screw on the hoop
- Hooped fabric should be taut, but not stretched
- Remove template before stitching
Attaching and Removing Hoop
Owner's manual pg.___
Adjusting Embroidery Hoop
Owner's manual pg.___
• This adjustment process calibrates the needle to the center of the embroidery hoop
• It is only necessary to complete this process once as it will apply to all the hoops
- Make sure that the module s properly attached to the artista 200
- Touch the external Setup button
- Select the Embroidery Settings option
- Insert the embroidery tempoate into the Large Oval hoop and attach to the module
- Touch “Check”
- The hoop position will be read and the hoop movement will stop with the needle positioned over the
center marking of the hoop
- If the needle is not positioned over the center properly, use the arrows on the screen to make
adjustments
- Touch OK
- The setting is now saved and you may touch Esc to leave this menu as well as the Setup menu.