Bernina 750 QE, Руководство пользователя

Страница: 23 / 198

22
Sewing preparation
threading the upper thread
⦁ raise the needle and presser foot
⦁ turn power switch to «0» (off)
⦁
place foam pad on the spool pin
⦁ place spool on pin so that the thread unwinds clockwise
⦁ attach appropriate spool disc
removing the needle
⦁ raise the needle
⦁ remove or lower presser foot (see page 24, 30 )
⦁ turn power switch to «0» (off)
⦁ loosen the needle clamp screw 1 using the gray screwdriver
⦁
pull the needle down to remove
Inserting the needle
⦁ flat side of needle to the back
⦁
insert the needle as far as it will go
⦁ tighten needle clamp 1 using the gray screwdriver
changing the needle
appropriate spool disc
Diameter of thread spool determines disc size. There must be no
gap between the disc and the spool.
⦁ hold the thread and lead it from the spool along the direction of the arrow
into the rear guide 1
⦁ then into slit of upper thread tension 2
⦁
pull thread down to the right of the take-up cover and around 3
⦁ take thread up to the left of the cover and around 4 , placing it in the take-up
lever
⦁ take thread down and through guides 5 and 6
⦁
thread the needle (see page 24 )
1
2
1
3
4
5
6
034247.71.04_2014-02_Manual_B750_EN