Bernhard ED3000, Руководство пользователя/Инструкция по эксплуатации

Страница: 12 / 48

12
EXPRESS DUAL • ED3000
© Bernhard and Company Limited
6.1
Mower Preparation
Units of up to 36” long can be ground
in frame, this includes most machines
including Greens mowers and Fairway
units. In order to spin / drive the reel,
one end of the reel shaft drive must be
exposed. This will require the removal
of the hydraulic motor, the chain / belt
or cover depending on which type
of unit is being ground. This should
be done before the mower is on the
grinder (see example Fig. 6.1).
Ensure that the mower is clean and
that both reel and roller bearings are
in good condition. Also ensure that
the bedknife has been sharpened, if
necessary, and replaced with a small
amount of clearance between it and the reel.
6.2.
Mounting Mower
The mainshaft / Grinding stone should
be wound down to its lowest position
and the unit placed on the table. The
unit should then be carefully moved
towards the multifix brackets or front
roller brackets, which can be adjusted
in any direction to allow the unit to be
fixed in such a position that the grinding
wheel can be raised towards the reel
without coming into contact with either the
bedknife or the front roller/groomer.
With the mower correctly positioned the radiused
pressure bar) is moved forward to rest on the rear of the
mower and locked in position by operating the toggle switch on
the operator control panel downwards. The operator should release
the toggle switch as the pressure bar engages the cutting unit thus retaining pressure
on the mower until the grinding operation is completed. A backing up plate is supplied to
protect the rear of the units and to evenly disperse the force of the pressure bar across the
width of the mower (see Fig. 6.2).
6. In-frame Grinding
Fig: 6.1
Fig: 6.2