Bernette Sew&Go 1, Инструкция по эксплуатации

Страница: 31 / 52

sew&go 1 / 3
Stitch length dial
3 2
Sewing on buttons
1. Install the darning plate.
Change presser foot to button-sew-on foot.
Position the work under the foot.
Place the button on the marked position and
lower the foot.
- Set the stitch selector dial on " " and
sew a few securing stitches.
- Select zig-zag stitch with a stitch width
according to the distance between the two
holes of the button. Turn the handwheel to
check if the needle goes into the right and
left hole of the button without any
obstruction. Slowly sew on the button with
about 10 stitches.
- Select stitch " " and finish the sewing on
button by sewing a few securing stitches.
2. If a shank is required, place a darning needle
on top of the button and sew.
3. For buttons with 4 holes, sew through the
front two holes first, push work forward and
then sew through the back two holes as
described.
Please Note:
No "S1" marking is shown on the stitch length
dial by model sew&go 1.
29
1