2. Specifications
Capacity
Threading
Pipe……………….…………………………..1/8” to 2”
Bolt……………………………………………1/4” to 2”
Cutoff
Pipe……………………………………………1/8” to 2”
Bolt……………………………………….……1/4” to 1”
Power Supply
Volt………………....120v 50-60 Hz single phase AC
Motor…………….………………………….…..1/2 HP
Weight (machine only)...………………...…….80 lbs.
3. Function/Operation Description
3.1 Using BT-30033 pipe cutter
•
Swing die head and reamer away to out-of-way position.
•
Lower pipe cutter down to pipe.
•
Move carriage to adjust cutter wheel position to where the pipe will be cut.
•
Tighten the pipe cutter handle and make sure the two rollers and cutter wheel touch the pipe
•
Turn switch to “forward” position and step on the foot switch.
•
Keep turning the pipe cutter handle until pipe is cut off.
•
Release footswitch and switch it OFF position.
•
Return pipe cutter to out-of-way position.
3.2 Using BT-30032 reamer
•
Swing pipe cutter and die head to out-of-way position
•
Lower reamer (BT-30032) and align with pipe
•
Extend reamer by pushing Latch and sliding knob toward pipe until latch engages square bar
•
Switch to forward position and step on foot switch.
•
Moving carriage toward to pipe and complete reaming the pipe
•
Retract reamer bar ad return reamer to out-of-way position.
3
