All Bands High Sensitivity Radio
K032
Instructions for Use
Please read and retain these instructions for future reference
v001: 01/09/21
Note:
•
Always be safety aware when operating the radio by AC mains power.
•
Please keep the unit away from damp and humid conditions
–
water and electricity do not mix.
•
When connected to the mains power, keep the radio out of the reach of children.
•
This unit is operated by 230AC Mains
–
50Hz.
3 RADIO OPERATION
1. TURNING THE RADIO ON OR OFF
To switch the radio on, rotate the ON/OFF/VOLUME knob (7) clockwise until a click is heard. The blue LED
KNOB backlight (10) will light up. Turn the knob anti-clockwise to switch the radio off, the LED KNOB
backlight will go off.
2.BAND SELECTION
Turn the radio on and slide the upper BAND SELECTOR switch (4a) up to select FM/AIR/MB or AM. Set the
upper band switch at AM, and then select MW, LW, SW1-2 bands with the lower band switch(4b).
3. SEARCHING FOR A STATION
Searching for a Station
After selecting the desired band (4), turn the FAST TUNING knob (8) or the SLOW TUNING knob (9) to set the
red DIAL pointer (3) at the desired station.
Adjusting the volume
After switching the unit on, increase the sound volume by turning the knob (7) in a clockwise direction.
Decrease the volume by turning it in an anti-clockwise direction and the selection ranges between 0-10.
It is recommended to set the volume at a medium level to start with.
Connecting earphones
To avoid disturbing others while listening, earphone or headphones (not supplied) can be connected to the
3.5mm dia. Earphone Jack.
Insert the pin at the end of the cord fully into the Jack (6) and make sure the volume level is set at a low to
medium setting before listening. Increase the level in small increments until the desired level has been
reached.
Caution!
Listening through earphones with the volume set too high may cause permanent hearing
damage!
