bergmann Magne, Руководство пользователя

Страница: 5 / 12

Page 5
Pic. 1.
1. Place the turntable on a stable, adjustable rack or shelf.
2. Add oil to the bearing, appr. half full. See Pic. 1.
Mount the subplatter in the bearing. The flat side upside, Pic. 2, and let it sink. Remove the subplatter again.
If oil is pressed out of the bearing, the amount is correct, Pic. 3. Wipe away the surplus of oil.
Note : Be aware the oil does not flow into the airbearings air hole.
Mount the subplatter again.
Note: The airbearing and subplatter must be absolutely clean to avoid friction and noise.
Setup Manual.
Pic. 7.
Pic. 2. Pic. 3.
3. Mount the belt around the subplatter and motor pulley, Pic. 4 and 5.
Mount the platter, Pic. 6, and adjust the rack or shelf in level.
Pic. 4. Pic. 5. Pic. 6.
4. Install the airsupply in a horizontal position.
Connect the airtube: one end to the airsupply, and one end to the turntable air input, Pic. 7.
Plug in the powercord, to the airsupply and the outlet.
Note: It is very important, to place the airsupply in an indoor environment, to prevent condense to enter
the system!
5. Turn on the airsupply, and start the platter. If any noise is caused by the bearing, an airflow adjustment is
required. Adjust the airflow at the backpanel.
Important: Do not turn off the adjustments valves on the turntable when the airsupply is operating.
surplus of oil