Beretta 20171580, Руководство по установке

Страница: 9 / 25

2 | Installation
9
2.4
Storage
The product must be stored of according to the regulations in
force.
2.5
Handling and removal of the packing
Before unpacking, personal protective clothing should be worn and
used transport means and tools suitable for the size and weight of
the unit.
The product can be handled manually.
1 Handles
1 Document envelope and material supplied as kit
2 Polystyrene elements
Follow the below instructions for packing removal and product handling:
– transport the equipment in the installation place
– open the cardboard packaging
– remove the document envelope
– take out the device by lifting it up
– remove the polystyrene elements
– remove the polyethylene bag
In manual operation it is compulsory to respect always the
maximum weight per person provided for by the national laws and
standards.
Handle with care
The packing material must not be disposed of in the surrounding
environment and must be kept out of children reach, as it can be
dangerous. It must be disposed of according to the regulations in
force.
2.6
Place of installation
The location of BREVA IN devices must be determined by
the system's designer or by another competent person, and must take
into account the technical requirements, as well as any current local
regulations.
The product uses R32 refrigerant gas and must be installed in
rooms with a minimum floor area, as indicated in the following
table, depending on the total refrigerant charge of the system
(given by the sum of the factory charge of the outdoor unit and, if
appicable, the additional charge).
The amount of refrigerant charged inside the unit refer to the
INSTALLATION AND TECHNICAL SERVICE INSTRUCTIONS of
outdoor unit used.
Minimum floor area for wall installation
mc A min mc A min
kg
m² kg m²
0.2
No requirements
2.1 4.2
0.6
2.2 4.61
0.8
2.3 5.04
1
2.4 5.49
1.1
2.5 5.96
1.22
2.6 6.44
1.225
1.43 2.8 7.47
1.3
1.61 3 8.58
1.4
1.87 3.4 11.02
1.5
2.15 3.8 13.77
1.6
2.44 4.2 16.82
1.7
2.76 4.6 20.17
1.8
3.09 5 23.83
1.9
3.44 5.4 27.8
2
3.81 5.8 32.07
mc: refrigerant charge of the system
A min: minimum floor area for indoor unit
BREVA IN is designed for indoor wall installation:
– install the indoor unit in the room to be air-conditioned
– its position must allow for the circulation of treated air in the
whole room
– consider an area where there are no obstacles to the regular air
delivery and intake
Check that:
– the installation site area is at least 3 sq.m
– the support wall is able to support the device weight
– the wall section does not feature building supporting elements,
pipes or power lines
– the supplied wall plugs are suitable for the chosen support wall
Avoid:
– installing the device in hallways or passageways
– any obstacles or barriers that will cause the expelled air to
recirculate
– locations with aggressive or explosive atmospheres or with
inflammable fluids
– direct exposure to sunlight and proximity to heat sources
– humid locations or positions where the unit could come into
contact with water
– environment containing oil vapours
– locations with high frequency contamination