Bercomac 700968-1-33V, Руководство пользователя

Страница: 12 / 60

Assembly and initial set-up
10
You must change the position of the hitch to put it in
operation mode (the hitch is at the rear of the engine)
1. After following the reception instructions,
A. Unbolt the hitch (item 1) from its initial packing
position. Keep the bolts only.
B. Install the hitch (item 1) in the position shown.
Secure in place using the six bolts (item 2)
removed previously and six new 1/2 "nylon
insert lock nuts (item 3) provided in the
hardware bag.
OPERATION POSITION:
2. Once the rear hitch is properly repositioned, remove
the bracket previously installed under the engine
mount to allow the hitch to be repositioned.
Chute installation
1. Install the nylon rotation ring (item 1) over the
opening (item 2) as shown and align the notches.
2.
Install the rotation ring (item 1) over the opening as
shown. Place grooves of the rotation ring onto the
grooves of the rotation motor and place notch (A and
B) as shown.
3. Install the chute (item 1) over the nylon rotation ring
(item 2).
a. Turn the chute to make sure it turns freely.
Place the chute to the right as shown.
b. Insert the hex bolts 1/4’’ x 1’’ (item 3) under the