Berbel Smartline BIH 100 ST, Инструкции по эксплуатации и монтажу

Страница: 23 / 36

23
Operation
6005736_0 – 25.03.2021
EN
4.2.2 Run-on function
The device comes with a run-on function. When the function
is used, the device continues to work 10 minutes after being
switched off.
In recirculated air mode, it is necessary to use the run-on
function so that the device can remove the remaining
odours. Using the run-on function increases the life of the
filter filling. The filter filling must be replaced at regular
intervals.
The run-on function can be switched on manually or
automatically. The device is delivered with the automatic
run-on function active.
Button Function
Automatic
The device is switched on with power level 1.
☞
Press button 1x.
y
The device switches off.
y
The run-on time (10 minutes) starts
automatically in power level 1.
y
The power level 1 button flashes.
If the button is pressed again, the device shuts
off completely.
Manual
The device is switched on, and any power
level is selected.
☞
Press button 1x.
y The run-on time starts in the selected
power level and switches off after
10 minutes. If the power level POWER is
selected, the device automatically switches
back to power level 3 after 6 minutes.
y The button for the active power level
flashes.
If the button is pressed again, the run-on
function stops.
Automatic or manual setting
The device is turned off.
☞
Press and hold the button for longer than
10 seconds.
y All buttons flash.
☞
Press the button at the same time.
y The automatic run-on function is activated
when the button is constantly illuminated.
y The manual run-on function is activated
when the button is not illuminated.
4.2.3 Hob lighting
The hob lighting is fitted with energy-saving LED lighting.
The lighting can be used at any time and independently of
the fan.
Switch illumination on/off
Button Function
☞
Press button 1x, in order to switch the hob
lighting on or off.
Dim the lighting
Button Function
☞
Press and hold the button to start the
dimming procedure.
☞
Release the button when the desired
brightness is reached.
When the lighting is switched off and on
again, the brightness is back to 100%.
4.2.4 AutoRun
Devices equipped with the AutoRun module start
automatically when the cooktop is turned on. When the
cooktop is turned off, the device switches to run-on function
and then switches off.
Button Function
Setting automatic AutoRun
The device is turned off.
☞
Press and hold the button for longer than
10 seconds.
y
All buttons flash.
☞
Press the button at the same time.
y The automatic AutoRun function is
activated when the button is constantly
illuminated.
y The automatic AutoRun function is
deactivated when the button is not
illuminated.