Berbel Downline Infinity BKA 90 DLI, Инструкции по эксплуатации и монтажу

Страница: 16 / 44

16
Installation
6006047_0 – 02.09.2021
3.5.5 Install recirculating air kit DL BUF
Installation variant for recirculated air mode with active
carbon filter.
The instructions for installation variants with blow-out
grate kit must be observed.
The height of the recirculated air filter must be set such that
complete folding up is possible at all times for removal of the
filter cartridge.
☞
Unscrew the screw on the side of the recirculated air filter.
By trimming, it is possible to align the shallow duct with the
spacing between the connections:
y
Between the fan‘s housing and circulating air bend with
deep base cabinets.
y
Between the circulating air bend and recirculated air filter
with high base cabinets.
D
“3.5.3 Check the dimensions” (page 13).
For the following steps, the adaptors of the air-carrying
components (e.g. circulating air bend, shallow duct sections)
must be sealed with sealing strip after they have been fit
together.
☞
Insert the circulating air bend in the connection on the
fan housing.
☞
Align the recirculated air filter with the flap device to the
access side. When doing so, observe the specification on
the device.
☞
Adjust the recirculated air filter position.
> 20
> 100
x
15
☞
Adjust the recirculated air filter to the appropriate height:
y
Height-adjustability of at least 20 mm is necessary,
in order to be able to install the shallow duct sections
afterwards.
y
The distance from the underside of the recirculated air
filter to the floor is at least 100 mm.
y
The recirculated air filter can be folded up at any time
to remove the filter cartridge.
y
The recirculated air filter must be set sufficiently high
that the cabinet base does not prevent folding back.
☞
Determine the length (x) of the shallow duct.
☞
Unscrew the screw on the side to lower the recirculated
air filter.