BeON BN-5509, Инструкция по эксплуатации

Страница: 12 / 16

12 INSTRUCTION MANUAL

When the time expires, the device will automatically turn off.
Heat maintenance

When this mode is selected, the device will operate at 1450 W/220 S
PROTECTIVE FUNCTION

PROTECTION FUNCTION AGAINST INCORRECT OPERATION

This function is triggered when dishes made of non-conforming material or with a diameter less
than 12 cm are installed. When attracted, the tile will check the compliance of the dishes.

FUNCTION OF PROTECTION AGAINST OVERHEATING OF THE INTERNAL PARTS OF THE DEVICE

PROTECTION FUNCTION AGAINST POWER SURGES AND OVERLOADS

THE FUNCTION OF AUTOMATIC SHUTDOWN (if no action is taken within 2 hours).

The induction surface of the plate is equipped with a microprocessor that tests the operation of
the device. If a deviation from the normal mode is detected, or
faults the induction surface is
automatically switched off and an error code is displayed on the digital display.
CLEANING AND MAINTENANCE

To avoid various damages, always keep the surface of the appliance clean.

When cleaning the glass-ceramic panel, it is recommended to use liquid detergents, special
cleaning agents for glass-ceramic, warm soap solution.

Do not use caustic or abrasive cleaning products - they may scratch and/or damage the coating.

Remove light dirt on the surface of the stove with paper towels.

Do not immerse the tile in water to remove dirt. This may cause it to malfunction.

Do not use harsh, synthetic, and wire brushes.

If the appliance fails, do not attempt to repair it yourself. We strongly recommend contacting
an authorized service center.

To avoid damage, only transport the device in its original packaging. After transporting or
storing the device at a reduced temperature, it must be kept at room temperature for at least
two hours.

It is recommended to use the device at a temperature of +5 C to +40 S.

When transporting, loading, unloading and storing products, the following requirements should
be followed, in addition to those set out in the operating instructions:
- do not expose the product to significant mechanical loads that may damage the product
and / or break its packaging;
- avoid getting water or other liquids on the product packaging.

Make sure that the product is free of water before transporting or storing it at a sub-zero
temperature. All surfaces of the product must be dry.

Protect the instrument from extreme temperature changes and exposure to direct sunlight.

Store the device in a dry place, out of the reach of children and animals.