Operation
46
Shutting down the projector
1.
Press
POWER
and a confirmation
message displays prompting you.
If you don't respond in a few seconds, the
message will disappear.
2.
Press
POWER
a second time. The
POWER indicator light
flashes orange,
the projection lamp shuts down, and the
fans will continue to run for approximately
90 seconds to cool down the projector.
• To protect the lamp, the projector will
not respond to any commands during
the cooling process.
• To shorten the cooling time, you can also activate the Quick Cooling
function. See
for details.
3.
Once the cooling process finishes, the
POWER indicator light
is a steady
orange and fans stop.
4.
Disconnect the power cord from the power putlet if the projector will not be
used in an extended period of time.
5.
When
Instant Restart
is
On
, users can restart projector immediately within
90 secs after turning off projector.
(Projector will maintain 30% of power
during the 90 secs)
When
Instant Restart
is
Off
, users need to wait lamp to cool down to restart
the projector.
When instant restart is on, quick cooling item will be grey out
• If the projector is not properly shut down, to protect the lamp, when
you attempt to re-start the projector, the fans will run for a few minutes
to cool down. Press Power again to start the projector after the fans
stop and the POWER indicator light turns orange.
• Actual lamp life may vary due to different environmental conditions
and usage.
I
I
I
I
