EN-23
1.
Turn off the projector.
2.
Unplug the power cord.
If the projector is installed in a ceiling
mount, remove it from the mount.
Place a protective sheet (cloth)
beneath the projector. Turn the
projector over so you can access the
lamp cover.
3.
Loosen the screw in the lamp cover and
remove the cover.
4.
Loosen the two screws from the lamp
module.
5.
Pull up the handle, and then pull out the
lamp unit by the handle.
6.
Insert a new lamp module into the projector
and tighten the screws.
7.
Replace the lamp cover and tighten the
screw.
8.
Turn on the projector. If the lamp does not turn on after the warm-up period, try
reinstalling the lamp.
9.
Reset the lamp hour. Refer to the Setting (Computer / Video Mode) menu.
4
5
3
Dispose the used lamp according to local regulations.
Ensure that screws are tightened properly. Screws not tightened fully may
result in injury or accidents.
Since the lamp is made of glass, do not drop the unit and do not scratch the
glass.
Do not reuse the old lamp. This could cause the lamp to explode.
Be sure to turn off the projector and unplug the AC power cord before
replacing the lamp.
Do not use the projector with the lamp cover removed.
http://www.pureglare.com.au
