Driver Installation
Use the drivers supplied by the diskette included in this product.
For detail description, please refer to readme.doc or readme.exe in
the diskette.
Troubleshooting
If you experience any problems with the AEN100/101, first make sure the
appropriate driver is loaded, the proper cable is connected to the adapter
port and the hub complies with the adapter specification, such as 10Mbps
10Base-T or 100Mbps 100Base-TX, then check the LED. The AEN
100/101 provides two LEDs to indicate network status:
•
10M/Link/Activity
A yellow LED indicates if the 10Mbps UTP has been LINK ok or not.
When the light is OFF, it indicates that the 10Mbps UTP port has not been
connected or LINK not ok. When the light is ON, it indicates that the
10Mbps UTP port LINK ok. When the light is BLINKING, it indicates
that there is traffic flow on the network that the card is connected to.
•
100M/Link/Activity
A green LED indicates if the 100Mbps UTP has been LINK ok or not.
When the light is OFF, it indicates that the 100Mbps UTP port has not
been connected or LINK not ok. When the light is ON, it indicates that
the 100Mbps UTP port LINK ok. When the light is BLINKING, it
indicates that there is traffic flow on the network which the card is
connected to.
