Benjamin Heating products WK400, Руководство пользователя

Страница: 7 / 16

-6-
POWER FAILURE OPERATION
NOTE: DO NOT operate your appliance, unless your total heating system has been designed and installed
to operate properly without electricity .
1. Remove the blower door and filter.
2. Using a non-combustible material, brace the draft door open (1/4" maximum).
3. Open all warm air registers and dampers.
4. Open the furnace room door & the basement door, to permit gravity air flow circulation.
5. Maintain the fire at 1/2 normal levels.
6. Inspect the fire at frequent intervals to ensure safe operation.
FLUE FIRE
1. Call the Fire Department.
2. Prepare to evacuate the house.
3. Shut off the main power switch to the furnace.
4. Diminish the fire in the furnace by closing all combustion air openings.
5. DO NOT remove the flue pipes until the fire is completely out.
6. Have the chimney inspected and repair the flue before using it again.
DO NOT STORE FLAMMABLE MATERIALS OR LEAVE PAPER OR RAGS IN THE VICINITY OF
THE FURNACE
Burn WOOD only. USE PAPER TO START A FIRE ONLY.
Remove ash at regular intervals to prevent residue roll out from the fire door.
DO NOT fill the firebox above the smoke baffle at top of fire door frames.
DO NOT use fluids, gasoline, oils or chemicals to start a fire.
DO NOT BURN GARBAGE, tar products, gasoline, plastics, drift wood or materials containing salt or
chemicals. This is extremely dangerous and will void the warranty. Burn wood only. Fuel storage must
conform to local ordinances having jurisdiction.
CLEANING AND MAINTAINING YOUR "WK400"
Establish a routine for the storage of fuel, care of the appliance and firing techniques.
Check daily for creosote build up until experience shows how often cleaning is necessary.
Be aware that the hotter the fire, the less creosote is deposited. Weekly cleaning may be necessary in mild
weather even though monthly cleaning may be enough in the coldest months. Have a clearly understood
plan to handle a chimney fire. Ensure that the heat exchanger, flue pipe and chimney are cleaned at the
end of the heating season to minimize corrosion in the summer months.
NOTE:
Keep the furnace, vent pipe and chimney clean. This will increase efficiency and reduce the risk of soot
and creosote fires.
Solid fuel requires a sufficient supply of air for combustion and combustion air is required above the fuel
bed (over fire slot at the top of the door).
Clean and inspect as necessary (at least yearly).
ASHES
Ash should be removed before it reaches the bottom of the fire door frame. Sand or ash should be 1 1/2"
below the bottom of the fire door frame. This will ensure proper air flow thru the fire. Ashes when
removed from the furnace should be placed in a metal container with a tight fitting lid and immediately
removed to a safe location. Ashes often contain hot dormant coals.