Version 0.5
10 February 2014
VERSION
1
X
X
WAKE_UP
1
X
class: 0x71 COMMAND_CLASS_ALARM
The Alarm Command Class is used to receive alarm notifications and security related events from other
devices.
class: 0x85 COMMAND_CLASS_ASSOCIATION
The Association Command Class is used to configure devices to send notifications to the Internet Gateway.
class: 0x20 COMMAND_CLASS_BASIC
The Basic Command Class is used as a fallback mechanism when trying to communicate with devices that do
not support any of the Command Classes that are controlled by the Internet Gateway.
class: 0x80 COMMAND_CLASS_BATTERY
The Battery Command Class is used to obtain battery information from devices.
class: 0x70 COMMAND_CLASS_CONFIGURATION
The Configuration Command Class is used to configure device-specific settings. Refer to the manuals of the
device in question for more information.
class: 0x72 COMMAND_CLASS_MANUFACTURER_SPECIFIC
The Manufacturer Specific Command Class is used to identify the manufacturer and device type of a device.
This information is used to identify and configure the device in the benext Graphical Web-interface.
class: 0x32 COMMAND_CLASS_METER
The Meter Command Class is used to request the value of a Z-Wave enabled electric, gas, water or other kind
of meter.
class: 0x8F COMMAND_CLASS_MULTI_CMD
The Multi Command Class can be used for sending multiple commands at the same time, increasing Z-Wave
network performance.
class: 0x8E COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION
The Association Command Class is used to configure devices to send notifications to the Internet Gateway.
This Command Class can be used for devices that consist of multiple sub-devices. See also the Multi Channel
Command Class.
class: 0x60 COMMAND_CLASS_MULTI_CHANNEL
The Multi Channel Command Class is used to support devices that consist of multiple sub-devices, for instance
a quad-socket power switch.
class: 0x73 COMMAND_CLASS_POWERLEVEL
The Powerlevel Command Class is used to check the connection quality between two Z–Wave devices.
class: 0x75 COMMAND_CLASS_PROTECTION
The Protection Command Class can be used to set a device in ‘protected mode’. Protected mode can be seen
as some kind of child-lock, disabling for example any buttons on the device.
