BeneVision TM80, Руководство оператора

Страница: 119 / 240

BeneVision TM80 Telemetry Monitor Operator’s Manual 10 - 1
10
Monitoring Noninvasive Blood Pressure
(NIBP) (Optional)
10.1 Pairing Introduction
NIBP (non-invasive blood pressure) data is measured by BP10 using the oscillometric
method. This measurement can be used for adult and pediatric patients.
You can connect a telemetry monitor to a BP10 via Mindray Patient Area Network
(abbreviated as MPAN). The process of establishing connection between the telemetry
monitor and the BP10 is called “pairing”.
When the telemetry monitor is paired with the BP10, measured NIBP data and NIBP-related
technical alarms will be transferred from the BP10 to the telemetry monitor. You can view
NIBP data and NIBP-related technical alarms and physiological alarms on the telemetry
monitor’s screen.
For MPAN specifications, refer to A.7.1 Mindray Patient Area Network (MPAN)
Specification . For the functionalities and operations of the BP10, refer to BP10 NIBP
Module Operator’s Manual .
10.2 Pairing a Telemetry Monitor with a BP10
10.2.1 Pairing Procedures
Before pairing the telemetry monitor with a new BP10, first unpair the already connected
BP10 by following steps in
10.3 Unpairing the Telemetry Monitor with the BP10 .
To pair a telemetry monitor with a BP10, follow this procedure:
1. Press the MPAN key on the right panel of the BP10. The “Pairing...” message will dis-
play in the prompt message area of the BP10.
2. Press the key to enter the main menu of the telemetry monitor.
3. Tap Wireless Modules .
4. Tap MPAN , and then select Connect to BP10 .
The telemetry monitor starts searching the BP10 devices in the vicinity and displays
the devices that can be connected under
Devices . Make sure that the device you
wish to connect appears in the list of devices. If not, repeat Steps 1 to 4.
5. In the list of devices, select your desired device and tap Connect . Once the device is
connected successfully, the status will be changed from Disconnect to Connected .