11 - 12
REAR SHOCK ABSORBERS
COOLANT LEVEL INSPECTION
The rear shock absorbers are equipped with a spring
preload adjusting ring. The preload of the rear
shocks can be adjusted in compliance with the driv-
er's weight and loading condition, driving method
and road conditions. Adjust when vehicle is stable
on the main stand or side stand, turn the preload
ring to the place required.
To check the coolant level:
1. Use the key to open the glove box
2. Shine a flashlight into the front legshield area next
to the front fender to illuminate the coolant reservoir.
3. The reservoir is marked with a H (High) and L
(Low) level marking. If the fluid level is low add cool-
ant until it reaches the H mark.
4. To add fluid, remove the two phillips screws from
the access panel on the upper left side of the leg
shield underneath the left handlebar.
5. Replace the rubber cap once fluid is added.
WARNING
!
Do not over fill the fuel tank. Do not allow fuel to
splash on the hot engine.
Please stop the engine and turn the ignition key
to " " (Off) position when you need to refuel.
Do not forget to reinstall the fuel tank cap after
adding fuel in case of evaporation to the air,
which is a waste of energy and would pollute
the environment. Don't use fire when refueling.
Recommended fuel:
91 OCTANE UNLEADED
GASOLINE ONLY
Fuel tank capacity:
2 Gallons
TORQUE VALUE
Upper fixing bolt: 37-44N.m
Lower fixing bolt: 22-29N.m
Adjustable
SOFTER
SOFTER
STIFFER
STIFFER
ADJUSTER
ADJUSTER
COOLANT
RESERVOIR
HIGH LEVEL
MARK
COOLANT
RESERVOIR
HIGH LEVEL
MARK
COOLANT
RESERVOIR
CAP
COOLANT
RESERVOIR
CAP
