Digital Multifunctional RC-Soundmodule
TBS Mini V2
Important notes about changes on the NEW TBS Mini V2
!!! MUST BE READ !!!
Most important: Receiver power supply must be 4V to
max. 6V !!!
This range is covered by most BEC receiver power supply.
New sound memory
- 16x larger → Enough for
24,8 minutes
of sound
- „Erasing Flash“ lasts about
45s
- Filling the new sound memory
completely
takes about
45 minutes
!
The
NEW TBS Flash V4 software
must be used for programming this TBS Mini
3W digital audio amplifier
on board
4Ohm and 8Ohm speakers
can be used
External amplifier connector
on top → see picture above.
All other connectors remain unchanged and are located one position lower than on the old TBS
Mini. Please see the TBS Mini V2 manual page 4 for all details.
The new connector allows direct usage of most 3
rd
party amplifiers.
Hardware volume controller
located on the Mini. Internal and ext. amplifier volume is set by this
controller. In parallel it is still possible changing the volume by the transmitter (if the Mini
parameters settings are accordingly)
External amplifier and a speaker connected directly to the TBS Mini can be used in parallel
Very important:
Connecting any 3
rd
party amplifier is FULLY on your OWN RISK regarding ANY damages
There will be no support for any 3
rd
party amplifier.
New connector:
External amplifier
Unchanged connectors
(same as old TBS Mini V1)
Volume
