5. Install the fan by 2.9 x 19mm self tapping screws
6. Solder all wires as shown at the end of this manual according to the desired
operation voltage !!!
7. Install cover by using two of the fan screws and
two additional ones below, supported by 10mm plastic
sleeves between box and cover.
Bend the edge covering the fan slightly to top.
This ensures a
free running
fan.
!!! No guarantee on damaged fans !!!
Make ABSOLUTELY sure the cover does NOT touch
any electric contacts below !!!
Cover screws are supported by 10mm plastic sleeves
between box and cover.
2 vertical smoke outlets
are shown on this picture.
The smoke controller is fixed by a “velcro” pad on the
cover.
9. Solder the heating elements to the solder lugs
inside
the box. 2x two heaters in series, as shown
on the picture below. The
distance
to the lid should be around
15mm
!!! Make sure the wires connect ONLY the solder lugs !!!
They must NOT touch the led or any other parts
Insert refilling tube here.
→ see instruction below !!!
15 mm
