2. Loosen the two inner clamps around the sleeve (Fig. 14), thereby the frontal axis for positioning is
released (Fig. 15). Insert the wheel so that it is fully inserted into the sleeve. Set the corresponding slope of
the stroller and then
firmly tighten all the clamps
.
CAUTION
When adjusting the stroller always remember the alighnment
of rear wheels so that the hard aluminum cubes
were always
vertically to the ground
(Fig. 16) - see the correct wheel
alignment settings.
In case of bad alignment of rear wheels the stroller is
shearing with unnecessary resistence. Which causes
increased vibration as well as enhanced risk of unclaping of
the clamps.
In addition there is an uneven tire wear!!
Exchange of the front wheel
The drawbar is fixed permanently in the position under the stroller. Mutual exchange is achieved through
the following steps :
1.
Loosen both inner clamps around the wheel sleeve (Fig. 14). This enables positioning of the front
wheel .
2.
Loosen the two outer clamps (Fig. 17). This enables manipulation with the drawbar, placed under
the frame of the stroller. Grip the front wheel folded under the stroller with one hand and use the
other hand to pull the drawbar forward to a suitable position (Fig. 18).
13
14
15
16
