13
STEP 10
(Mounting Power Unit)
1. Bolt the Power Unit to the Power Unit Stand, placing
the Vibration Dampener between the Power Unit and the
Power Unit / Safety Mounting Bracket. (See Fig. 10.1)
2. Install the Power Unit Fitting with O-ring to the Power
Port (Remove plastic plug; typically the port is labeled “P”)
on the Power Unit. Use Teflon Tape on the pipe thread
side of the Fitting only. (See Fig. 10.2)
3. Connect the Hydraulic Hose (90*End) to the Power
Unit Fitting. It is not necessary to use Teflon tape on JIC
fittings.
DO NOT OVER-TIGHTEN
. (See Fig. 10.3)
STEP 11
(Installing The Safety Release Cable)
1. Route the Safety Cable up through the Cable Guide and
bolt to the Safety Handle. (See Fig. 11.1)
2. Route the Safety Cable Down the Power Unit Stand
and through the Ground Plate to the Column. It may be
necessary to use cable ties to help with the routing of the
Safety Release Cable and the Hydraulic Hose.
(See Fig. 11.2)
3. Route the Safety Cable through the Ground Plate,
through Rear Leg, up the Column to the Safety Assembly.
Use the Cable Clips to secure the Cable to the Columns.
(See Fig. 11.3)
Fig. 10.1
Fig. 10.3
Fig. 10.2
Fig. 11.1
Fig. 11.2
Fig. 11.3