BendPak GP-7, Инструкция по установке и эксплуатации

Страница: 44 / 84

GrandPrix Two-Post Lifts
44
P/N 5900209 — Rev. D3 — Feb. 2020
Installing the Safety Covers
There are two Safety Covers, one for each Safety Assembly. Refer to Installing the Safety
Assemblies and the Safety Cable for more information about Safety Assemblies.
The Safety Covers are
not
interchangeable:
• The Offside Post Safety Cover can be installed in either orientation.
• The Powerside Post Safety Cover can only be installed in one orientation: there is a slot on the
front for the Safety Lock Release Handle and a hole in the bottom for the Microswitch Cable.
Both Safety Covers connect to their Posts via holes in the upper left and lower right corners.
To install the Safety Covers :
1. On the Offside Post, make sure the cover screws are installed in each block.
There must be enough space between the block and the screw to fit the Safety Cover.
2. Put the Safety Cover into position, then tighten both cover screws.
3. On the Powerside Post, make sure the cover screws are installed in each block.
4. Put the Safety Cover into position.
Make sure the Safety Lock Release Handle comes through the slot on the front and that the
Microswitch Cable comes through the hole on the bottom.
5. Tighten both cover screws.
Installing the Lift Arms
Lift Arms are what actually raise Vehicles off the ground.
Your Lift has four arms:
•
Two Straight Arms : install them at the rear of the Lift.
• Two Angled Arms : install them at the front of the Lift.
To install the Lift arms :
1. Raise a Lift Head two to three inches off the ground.
2. Move a Lift Arm into place in the Lift Head.
3. Install a Lift Head Pin through the Lift Head and the Lift Arm, then push a Snap Ring into its
grooves on the bottom of the Lift Head Pin.