89000109-002
xVue Touch Installation Manual
Rev 2
Page 4-6
© Honeywell International Inc. Do not copy without express permission of Honeywell.
For Use in Non-Certified Aircraft
Figure 4-7 Wired Configuration Module Circuit Card Assembly
(3) Strip the remaining end of the seven lengths of wire and crimp on socket connector contacts
included in the KSD 100EXP Configuration Module and Connector Installation Kit per IPC-A-610.
Set aside.
(4) From the KSD 100EXP Configuration Module And Connector Installation Kit, prepare J2 wire
harness by stripping wire ends and applying crimped socket connector contacts.
(5) Prepare J2 wire harness by crimping remaining socket connector contacts and inserting into J2
housing, provided in the KSD 100EXP Backshell Assembly Installation Kit, per Table 5-2 KSD
100EXP J2 Pin Descriptions (Viewed from LRU).
(6) Insert the seven socket connector contacts from the Configuration Module into J2 housing per
Table 4-1 Configuration Module (J2 Backshell) Pin Descriptions.
(7) Inside the backshell base, insert the Configuration Module CCA with the primary side (populated
side) facing down. Reference Figure 4-5 Configuration Module Circuit Card Assembly (Primary
Side).
(8) Secure the Configuration Module CCA with the center mounting screw and lock washer. Torque
screw to 4 ± 0.4 in-lbs (0.45 ± 0.05 Nm).
(9) Insert the J2 connector housing into the backshell base and secure with the two captive socket
head jack post screws.
(10) Insert the tiedown strap in the backshell base and secure the wire bundle.
(11) Install backshell cover to the backshell base with the two countersunk screws. Torque screws to 4
± 0.4 in-lbs (0.45 ± 0.05 Nm).
(12) Secure each cable harness shield ground to the J2 backshell assembly with the button head
ground screws and lock washers. Torque screw to 4 ± 0.4 in-lbs (0.45 ± 0.05 Nm).
Figure 4-8 Bottom Side of J2 Backshell
