Bender TM800, Руководство пользователя, Страница: 39 / 92

Commissioning and testing
39 TM800_D00165_00_M_XXEN/06.2015
5.2 Tests after switching on
Continue with chapter "Make settings (parameterisation)" on page 39.
5.3 Make settings (parameterisation)
All
settings can be carried out using the TMK-SET software. Alternatively, some
settings can be carried out via the TM800 menu (see diagrams).
Measure the supply voltage
of TM800 (terminals 0,
230 V). Voltage OK?
no
Make corrections
yes
Close the TM800's front
plate
Power supply or TM800
failure? - Remedy fault!
Does one of the three LEDs
below the display light up
and does anything appear
on the TM800's display?
no
Does TM800 indicate a
fault?
Make a note of the
message. Adapt the
signalling device to the
system or remedy the fault.
yes
yes
no
Call up menu "6. External
devices". Are addresses
and software versions of the
connected devices OK?
no
Correct the address settings
of the external devices.
yes
Optional: Use the TMK-SET
software to connect the PC
to the BMS bus of the
TM800. Call up the TMK-
SET function "Scan bus".
Are addresses and software
versions of the connected
devices OK?
no
Correct address settings of
the external devices.
yes
Test the system. Functions
OK?
no
Change the parameter
settings of TM800.
TM800 is ready for
operation
yes