Bender ISOMETER iso685-D-P, Руководство пользователя

Страница: 59 / 90

Settings Settings
iso685-D-P_D00170_00_M_XXDE/06.2016
59
10.1 2.8 Device
10.1 2.8.1 Trigger
Refer to “10.1 2.4.4.3 Trigger” .
10.1 2.8.2 Fault memory
Refer to “10.1 2.4.4.4 Fault memory” .
10.1 2.9 Service
The service menu can only be accessed by Bender Service staff.
10.1 3.0 Data measured values
The ISOMETER® stores certain measured values for a specific period of time. You can view
these data at the "Data meas. values" menu point. Navigate through the different views
using the and buttons:
•isoGraph data
Displays the insulation resistance and chrono-
logical sequence.
See “Device communication”
on page 64 .
•Insulation data
Displays the current insulation resistance, the
minimum insulation resistance measured and
the system leakage capacitance.
•IT system data
Displays the system phase-to-phase voltages
and the mains frequency (r.m.s. values)
•IT system data
Displays the system phase-to-earth voltages
•EDS data
Displays
I
∆L
and
I
∆n
in % and ampere. Use the
and buttons to switch between the two
options.
•EDS data
Displays the locating current for
Insulation fault location
10.1 4.0 Control
In the control menu, you can start a manual test reset, reset alarm messages and start an
initial measurement:
10.1 5.0 History
In the history menu, the faults detected by the ISOMETER® are displayed. For a detailed
functional description, refer to
“History memory” on page 39 :
10.1 6.0 Device settings
The device settings menu allows you to configure the basic settings for the ISOMETER®:
10.1 6.1 Language
Choose the language to be displayed by the ISOMETER®. For example, you can set the lan-
guages:
•TEST
Manual device test
•RESET
Reset of fault and alarm messages
•Start initial measure-
ment
All recorded measurements are discarded and a
new measurement is started
•EDS
Starting and stopping the insulation fault loca-
tion
•History
Overview of faults that have occurred
•Delete
Reset the history memory
•German
•English
•...